Sedikit Info Seputar
How To Install TWRP 3.0 On Samsung Galaxy S7 Edge
Terbaru 2017
- Hay gaes kali ini team All About Android, kali ini akan membahas artikel dengan judul How To Install TWRP 3.0 On Samsung Galaxy S7 Edge, kami selaku Team All About Android telah mempersiapkan artikel ini untuk sobat sobat yang menyukai All About Android. semoga isi postingan tentang
Artikel Android,
Artikel samsung galaxy s7 edge,
Artikel twrp, yang saya posting kali ini dapat dipahami dengan mudah serta memberi manfa'at bagi kalian semua, walaupun tidak sempurna setidaknya artikel kami memberi sedikit informasi kepada kalian semua. ok langsung simak aja sob
Judul:
Berbagi Info Seputar
How To Install TWRP 3.0 On Samsung Galaxy S7 Edge
Terbaru
link: How To Install TWRP 3.0 On Samsung Galaxy S7 Edge
Berbagi Artikel Tentang How To Install TWRP 3.0 On Samsung Galaxy S7 Edge Terbaru dan Terlengkap 2017
A few minutes ago, I published an article on how to install TWRP recovery on Samsung Galaxy S7. If your device is Samsung Galaxy S7 and not Samsung Galaxy S7 Edge please use the guide provided in that article to install TWRP 3.0, not this.
Before using this guide to flash TWRP on your device, make sure it falls under one of the following supported models: SM-G935F, SM-G935FD, SM-G935X, SM-G935W8.
INSTALLING TWRP ON GALAXY S7 EDGE
su
dd if=/sdcard/twrp.img of=/dev/block/platform/155a0000.ufs/by-name/RECOVERY
If you want to flash via adb on your PC, connect the device via USB cable and launch adb in Command prompt. Then key in these commands:
adb shell
su
dd if=/sdcard/twrp.img of=/dev/block/platform/155a0000.ufs/by-name/RECOVERYStep Five: Done, and that's all.
Alternatively, you can download and install TWRP Manager app from Play Store then flash TWRP recovery from the app.
Method #2 (Non-Rooted Devices)
Step One: Download Odin, and twrp-3.0.0-0-hero2lte.img.tar
Step Two: Power off device and boot into download mode (press and hold Volume Down, Home and Power buttons at the same time. Once Warning alert displays, press Volume Up to load download mode)
Step Three: Extract and run Odin.
Step Four: Click on PDA/AP tab then browse and select the downloaded twrp-3.0.0-0-hero2lte.img.tar file.
Step Five: Click on Start and allow the flashing processing to complete. Done!
Note: Many devices will replace your custom recovery automatically during first boot. To prevent this, boot the device into recovery mode first before booting normally into system.
To boot into recovery mode, press and hold Volume Up, Home and Power buttons at the same time. Release the buttons once the recovery options are fully loaded on your screen.
That's all.
Please share and like this post if it has been helpful to you. If you have any questions or contribution, leave your comments in comments sections.
